Mon 20 December 2004 |
| I had a quiet day on my own, so I did something a bit different and worked on the AOA drain solution. The upper air port has a drain which has to be accessed from the lower skin of the wing. The plan was to make an additional nylon bushing. | 
|
| After turning down the nylon I then drilled the offset holes to the same layout as the AOA ports. | 
|
| The finished solution, the lower (left side) plug is the new part along with the mid in tube guide. Seems to work OK in theory. | 
|
| Mounted in the wing. Just about works but I think will need some shaping to try and change the angle the rod enters the wing void at... | 
|
