Tue 17 January 2006 |
| Continuing on cowl, we got close to a solution and drilled the lower cowl hinges. Once everything is resined / riveted together we can finish any trimming / additional build up. | 
|
| Got preped for flox / riveting of the side hinges. | 
|
| This time I after doing the rivetting I scraped the 'gaps' in the hinge with a piece scrap. | 
|
| Worked well and kept everything clean. | 
|
| I used some of the left over flox to stiffen the edge of the HS tips. | 
|
| The end result - for drying a pin was left in. | 
|
| I also played with the a possible forma for a 4" round cylinder - this might work well for any new inlets we might need. | 
|
