A slow day in general, the project seems to be grinding away with limited progress. I know it is all part of the process and to just keep on trucking, but motivation is hard at the moment.
Anyway, we continued with the rear skin, the upper locations could be squeezed, the rest were bucked.
The forward locations on the rear skin need to be shot/bucked BEFORE the tip-up angle brackets are added to the under side of the rear cross member. Hopefully we have got the order right - time will tell.
Then we hoped to fit the canopy roll bar and support installed. The problem however is the upper C channel - we shouldn't have rivetted it to the roll bar. Not sure how we are going to get out of this mess. One item to sort is a little interference between the rollbar brackets and the seat back jams.
