Tue 30 May 2006 |
| The 340 audio panel and 327 transponder both need D plugs through the sub panel - cutouts were made in both layers. | 
|
| To provide more support for the forward end of the rack (the back of the instruments) I sorted two straps to hold together three of the units. The SL30 rack need two .032 shims (one each side) to get the alignment right. The 430 doesn't have a location pre-drilled here, so.... | 
|
| A new location was added at the back of the 430, this was then match drilled to the sub panel stiffener, openned to #27's and dimpled for #6 screws. This also provide rear support for the whole stack. | 
|
| The complete system, very solid and should work well. The access hole for the audio panel needed openning further and the strap will need a couple of tweaks but basically ready for finishing. | 
|
