After some testing of the AoA I found the upper most red LED was dead. The LEDs are mounted on a mini-board which makes checking / replacement simple. An email sent to Rob @ AFS, hopefully I can get a replacement simply.
Update: After confirming I'd done the obvious tests Rob has dropped a new one in the post for me.
Then onto the flap switches and sensors. The switches need a little tweaking but look about right.
Lots of trial and error testing for the RAC pot and the flap actuator. It ends up being quite long (8" plus) and needing to be mounted very close to the pivot point. The final bracket I'll wait until the wings are back on to allow alignment of everything together.
