Home | Research | Delivery | Empennage | Wings | Fuselage | Finish | Engine | Electrical | GRTDecode

Thu 29 March 2007

More nose fairing work - this time the lower hole for the wheel. The nose section was the first to get a rough cut.
Then with the wheel in place I aimmed for a 1/2" gap around the tire. This is a first cut, I'll open up further later, but should get us going for the moment.
Finally decided the after brackets weren't working - too much stress / deformation of the glass structure, so drilled them off and made .063 spacers for the inner surfaces.
Carl Morgan