Home | Research | Delivery | Empennage | Wings | Fuselage | Finish | Engine | Electrical | GRTDecode

Thu 02 March 2006

Before putting the rear skin on, we dimpled the #6 screw locations.
Then clecoed the center 3 top locations.
After the two aft center locations were sorts, the upper center aft bracket could be done. I started using the squeezer - BAD idea, didn't set properly and ended up being drill out. Shoot and buck it!
Then continuing with the aft bulkhead, I did the bucking - not comfortable!
The back half is complete, Dad was suffering somewhat which cut short the day.
Carl Morgan